Spirax Sarco SC20 Stud Coupling
Part # : SC20SC
Price : $84.00
The Spirax Sarco SC20 Series Sample Cooler is designed to cool samples of boiler water, process liquor, or steam from vessels at high temperature and pressure. The cooler consists of a stainless steel coil, through which the sample flows, and a stainless steel body, through which cooling water flows in the opposite direction. A pre-drilled mounting bracket is incorporated
into both end caps. The SC20 is also available with a ferrule for connecting to an industry standard 1/2" sanitary clamp fitting.
- Process Liquors
Refer to the installation and maintenance instructions for full details, as insufficient information is given here for safe installation. To avoid the risk of scalding, it is ESSENTIAL that cooling water is flowing before opening the sample inlet valve. Always close the sample inlet valve before turning off the cooling water. Sample pipework becomes very hot under normal working conditions, and will cause burns if touched. We recommend the use of corrosion resistant pipework suitable for the fluid being sampled. Keep the length of all pipe runs to the minimum. Cooling water must be clean and free from scale forming salts. The sample cooler must be mounted vertically. The cooling water inlet is connected in 1/2" nominal bore pipe via an inlet valve. The cooling water outlet should be piped to an open drain or tundish. The sample inlet pipe should be in 6 mm O.D. tube. The sample inlet to the cooler can be taken direct from a boiler or steam line isolating valve, or if a Spirax Sarco TDS control system is fitted, from the take-off point provided on the blowdown valve. We recommend that a tundish piped to drain is located under the outlet, with sufficient space below it for a beaker or similar sample container.
No routine maintenance is required.
Safety Note Details:
Prop 65 Warning: